SigmaSIX DOBA System

ePro Q Pulse & Impact - 39 Code

This code was developed to ensure process control, fastening validation and error proofing for standard non shut-off pulse tools and even impact tools using open loop control for accuracy of ± 10 % depending on the tool and the application. The ePro Q (with 10039 code) is the only qualifier that can be used with stall pulse tools or impact tools. The Q will turn any stall tool into a precise shut-off tool system. With the use of a remote shut-off valve and cycle LED indicator, the ePro Q shuts off the air to the tool and fires a green LED, notifying the operator that the tool has run it's required cycle, counts it as GOOD and adds it to the batch count.      Impact wrenches require control in order to prevent over-torque of the fastener. The program assures accurate torque control (within 15%) of up to two different applications. Absolute error proofing is provided via rejection of re-hits, cross-threaded fasteners, slip-off / stripped screws or broken fasteners.

 

ePro Q Direct Drive ( Stall ) - 41 CODE

The Direct Drive program provides both precise torque control as well as full error proofing capability to normal "stall" type gear driven power tools. Clutch tools can be used by adjusting the clutch to the highest setting, thereby providing a "safety net" shut-off at the high limit of the specification. Stall-bar, swing-bar, screwdrivers and nutrunners can be controlled and error proofed using this program.      Tube-nut wrenches allow the operator to restart the tool after the rundown cycle in the reverse direction in order to rotate the socket to the open position. When using Tube-nut wrenches, the Direct Drive program ignores this reverse cycle, therefore allowing their use with no changes to the software.

 

ePro Q Shut-off - 42 CODE

Our Qualifier code in the ePro Q is now more simple to program and more versatile; any shut-off tool that vents the throttle to reset will be error-proofed without the need for special adapters or reporting tubes. This code was developed to ensure process control, fastening validation and error proofing using most any shut-off "T" type air tool.

 

ePro Q Direct Drive - 51 CODE

51 Code was developed to control Atlas-Copco’s LMP and LMD style twin-motor air tools.  With 51, the tool will be torque controlled and automatically shut-off.  Like Q-41, all of the standard features of error-proofing are provided including REHIT and CROSS THREAD detection as well as early throttle release.

 

 

ePro Q Push PIN - 60 CODE

We now have a Qualifier code for use with air hammers. This code was developed to ensure process control and error proofing for Press/Push Pin applications.

 

ePro FSC Transducer Control - 66 CODE

The 10066 program allows the ePro FSC controller to control pulse tools and our exclusive transducer-controlled impact tools. The exclusive magneto-elastic integral torque transducer with our closed loop control algorithm allows unparalleled speed, power and accuracy. The ePro FSC controller will shut off the tool within precise limits. HIGH and LOW limits are easily set and integral tool LED's respond to the torque limits. Error proofing is per the patented system features common to all codes.

 

Copyright © 2007 SigmaSIX LLC
Last modified: December 10, 2008